900Mhz 2.4GHz 5.8GHz wireless amplifier for -

 

Direct Sequence or Frequency Hopping Spread Spectrum radio modems

ANF-2401

Specification
  • Operating Range: 2400-2500 MHz
  • Operating Mode: TDD
  • Lightning Protection: Direct DC ground at antenna
  • DC Surge Protection: 600 Watts TVS @ 9 VDC
Mechanical & Environmental
  • Operating Temperature: -40 to +70 degree C
  • Power: 1.2 A @ 9 VDC
  • Amplifier: 4.7” L X 3.5” W X 1.5”H
  • DC Injector: 3.5” L X 3” W X 1.18” H
  • Amplifier: 0.9 lb
  • DC injector: 0.4 lb
  • RF Connector: N, Female
  • Smart Function: Yes
Transmitter Amplifier
  • Transmit Gain: up to 24 dB
  • Transmit input power:
  •     1 mW min
  •     200 mW max
Receiver Amplifier
  • Receive Gain: 15 dB typical
  • Frequency Response: +/- 1 dB
  • Noise Figure: 3.5 dB
   

Features

Designed for extending the range of 2.4 GHz wireless radio devices, the Smart-Amp is particularly effective when used with Direct Sequence or Frequency Hopping Spread Spectrum radio modems. The unit provides transmit power amplification and receives signal gain. Full output power of 1W is achieved with only 4mW input to the amplifier. Above 4 mW input, the smartamp attenuates the input signal power and maintains the output power typically at 1W. Substantial discounts available for OEMs and large volume purchases. Also available in 900Mhz & 5.8GHz versions. Contact sales office for details.
   
Ordering Information ANF-2401 - 1W amplifier
 
other SCADA Communication Products